|
Quantity
|
Total
|
||
|
|
|||
|
|
|||
Victron VE.Bus BMS to BMS 12-200 alternator control cable — is a specialized cable designed to transmit control signals from the VE.Bus BMS to the BMS 12-200, which is used to control charging from the generator (alternator). Thanks to this cable, the VE.Bus BMS can transmit information about the battery status and enable or disable charging from the generator, protecting LiFePO₄ lithium batteries from overcharging or excessive current.
Key benefits of the VE.Bus BMS to BMS 12-200 generator control cable
- Ensures synchronization between two BMS units: VE.Bus BMS → BMS 12-200
- Automatically controls charging from the generator depending on the battery status
- Ensures safe operation with Victron Smart LiFePO₄ batteries
- Prevents overcharging or overheating during generator operation
- Plug & Play – no additional configuration required
- A reliable solution for marine, RV, and commercial vehicle systems
Technical Specifications
- Part Number: ASS030510120
- Purpose: transmission of control signals between BMS
- Side 1: VE.Bus BMS (“Load Disconnect” output)
- Side 2: BMS 12-200 (“Remote” input)
- Signal type: logic, TTL-compatible
- Cable length: ~1.8 m
- Materials: flexible, heat-resistant cable with reliable insulation
- Connection: pre-made connectors with crimped terminals
Application scenarios
- Systems with a generator in campers or motorhomes
- Marine solutions with an onboard diesel generator
- Hybrid systems with LiFePO₄ charging from a generator
- Systems with dual BMS: VE.Bus BMS + BMS 12-200
- Scenarios where the VE.Bus BMS has primary control over the operation of charging sources
Compatible Victron Energy products
- VE.Bus BMS
- BMS 12-200
- Victron Energy Smart Lithium LiFePO₄ batteries
- Generators connected to the BMS 12-200
This cable is not compatible with the Smart BMS CL 12/100 or Lynx Smart BMS.